Previous Page
Next Page
Testing Index On-Line Catalog
Catalog - Page 29

A new operator will become a confident operator within the first few tests.  The N101-0897 uses a color monitor with “touch screen” control.  It is completely self-diagnostic including the harnesses and is equipped with our “Slide N’Lock” cradle for hands free testing.  Maintenance parts, such as the starter test solenoid and alternator “B” circuit regulator, are mounted on an access panel on the read of the tester for ease of replacement.

Alternator testing is performed using a fixed amount of applied load and confirms all internal circuitry of the alternator.  The starter test parameters are provided by the supplier and entered into the database at the factory.  A printer port is provided for connecting a printer to print out test results.  Results are printed as “GOOD” or “BAD” without any specific values that could be misinterpreted by the operator.  If the customer’s alternator or starter test result is good, the final screen also displays a list of some common associated problems that can be relayed to the customer  to aid in troubleshooting and gaining additional sales.  All data upgrades are accomplished via a Compact flash card.  The flash card is accessible via a panel on the rear of the machine.
Starter & Alternator Tester

The D201-0001-JBT is an all-in-one testing device that was designed for Parts Stores, Warehouses and Distribution Centers.  The tester provides the end user with capabilities previously available only to OEM manufacturers

  • Solenoid Pull-in test, Voltage Drop and Contact chatter
  • Test virtually every alternator available including BSS, LIN & clutch pulley alternators with less than 40 test harness combinations
  • Built-in digital oscilloscope for analysis of rectifier/diode & stator windings
  • Database is searchable by Part Number, Plug Number or Vehicle Application
  • Easy to operate touch screen with step-by-step connection instructions aided by full color pictures
  • The platform supports the various computerized serial communication protocols required to activate and test the alternator including BSS & LIN
  • Built-in digital oscilloscope for analysis of rectifier/diode and stator winding condition.  Also provides comprehensive measurement of regulator functions and terminal output signals.
  • The regulator terminal switching circuitry automatically configures the test harness to  match the required plug connections of the alternator
  • Alternator leakage test checks for faulty alternator components such as missing or broken insulators, defective diodes and regulators
  • Comprehensive test of the starter and solenoid functionality with the combination of measured electrical values and optional shaft speed measurements
  • The computer controlled variable voltage starter power supply tests solenoid pull-in with a programmable voltage to detect weak and defective solenoids
  • Analysis of starter components with "inertial" load and speed sensor.  The optional sensor evaluates starter pinion engagement and timing
  • Measure solenoid contact voltage drop, pull coil & hold coil current, early model "R" terminal connection - checks for contact chatter, pinion engagement and speed
  • Printed Pass/Fail reports
  • Distribution of test specifications via internet & USB
Technical Data Measured Parameters:
Output Voltage:  0-16 Volts (24V optional), Test 12-24V units
Alternator Leakage:  1-100 mA
Solenoid Voltage Drop:  0-5 Volts
Automatic Terminal Verification
Large Memory Capacity for Database
Starter Free Run Current:  0-200 Amps
Solenoid Current:  0-200 Amps
Starter Free Running Speed via Speed Sensor
Multi-Lingual Interface Available
DE & CSA Safety Certified

Previous Page Next Page
Testing Index On-Line Catalog
Catalog - Page 29