Previous Page
Next Page
Tools Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 242
H308-0130-CT-CTD
H308-0130-CT


CUTTING TOOLS

H308-0130-CT        CS130, 203 BEARING
H308-0130-CTD    CS130D, 6303 BEARING

•    Cuts the bearing retainer ring out
•    Production tool
•    Automatically centers the cutting bit in the alternator bearing
•    Built in stop collar in bit prevents damage to the aluminum frame
•    Replaceable cutting bit
•    Can be used with any cordless drill
•    Quickly produces a machined finish without a lathe
•    H308-0130-CTD has the length required to provide good distance from the stator and provides good visibility when cutting retainers.

Service Parts:
H308-BIT  Cutting Bit Only
H308-0004-CTFG
H308-0004-CTFGB
H308-0004-CTFGA

H308-0004-CTFG
DRIVE END HOUSING CUTTING TOOL

•    Convert all 3G & 4G housing to work with standard or countersunk pulleys.
•    Expand the usage of your 3G & 4G drive end housings
•    Cut off the aluminum ridge that fits inside the recess in the special pulley allowing use of standard pulleys
•    After the housing is modified, the complete unit can be sold less a pulley
•    Buy fewer pulleys and make more money

Operation:
1    With the old bearing still in place clamp housing in a drill press
2    Chuck the H308-0004-CTFG Cutting Tool in the drill chuck
3    Using a slow cutting speed lower the self-centering cutting tool down until the cutting stops
H308-0015-CTND
H308-0015-CTNDW
H308-0015-CTNDHP






H308-0015-CTDN

NIPPONDENSO INTERNAL FAN
DRIVE END HOUSING CUTTING TOOL

•    Salvage those look alike housings to get maximum usage
•    Not all pulleys will fit into the housing due to the large pulley OD that goes into the housing
•    This tool will allow you to bore out the drive end housing to accommodate the widest range of pulleys

Operation:
1    Chuck the H308-0015-CTDN Cutting Tool into your drill press and tighten
2    Place the housing to be cut on the table and lower the cutting tool into the bearing
3    Lock the housing in place
4    Set the drill press on the slowest cutting speed
5    Press down on the spindle lever slowly until the tool stops cutting
6    Your cutting job is complete
Previous Page Next Page
Tools Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 242