Previous Page
Next Page
Tools Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 260
G008-3225
G008-3225
Ford Housing Identification Tool

•    Prevent returned units caused by incorrect  mounting
•    Eliminate misapplications
•    Identify the Ford 3225 drive end housing from the 3226
•    Simple Go-No-Go Gauge.
G008-3230
G008-3230
Ford PMGR Housing Identification Tool

•    Identify Ford PMGR unit number 3230 & 3204
•    This tool only fits the 3230 Ford PMGR on starters such as F3DU-1100-BA, F3DZ-1100-B,         FZPU-1100-JA, F7PZ-11002-JA, SA-810-810, SA-865.
•    This is a Go-No-Go Tool

Operation:
Place the tool on the drive end housing, aligning the two solenoid mounting holes and the top mounting ear hole.  If the tool easily slides into all three holes, you have a 3230.  If the tool does not slide into all three holes, you have a 3204.  Remember, these are not interchangeable housings.
A158-0815-KT.
A158-0815-KT
FORD STARTER DRIVE HOUSING NEEDLE BEARING REMOVING KIT

Three easy steps and the bearing is out:
1    Set drive housing in round receiver and drill through center of the needle bearing
2    Remove the housing and place on plate.  Use special reamer to drill down to top of bearing.  Be gentle with reamer to bearing; touch easy
3    Use driver to remove bearing.  
A158-0810-1
A158-0810-1
FORD DRIVE END BUSHING INSTALLING TOOL

Kit contains:
1    Base
2    Two bushing drives
A158-0812


A158-0812

FORD DRIVE END DRILLING FIXTURE

Application: 
4 1/2” Ford drive end housing thru-bolts
Previous Page Next Page
Tools Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 260