Previous Page
Next Page
Tools Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 270
How to Prevent Premature Tool Failures: 
Lubricate All Threads with S109-1470 Anti-Sieze, P209-G4700 Gear Grease & P209-0321 Spray Lubricant
H308-0015-CTN
H308-0015-CTNDW

H308-0015-CTDN

NIPPONDENSO INTERNAL FAN DRIVE END HOUSING CUTTING TOOL

•    Salvage those look alike housings to get maximum usage
•    Not all pulleys will fit into the housing due to the large pulley OD that goes into the housing
•    This tool will allow you to bore out the drive end housing to accommodate the widest range of pulleys

Operation:
1    Chuck the H308-0015-CTDN Cutting Tool into your drill press and tighten
2    Place the housing to be cut on the table and lower the cutting tool into the bearing
3    Lock the housing in place
4    Set the drill press on the slowest cutting speed
5    Press down on the spindle lever slowly until the tool stops cutting
6    Your cutting job is complete
A158-3006
A158-3007
SOLENOID CONTACT TERMINAL ALIGNMENT FIXTURES

A158-3006    NIPPONDENSO
A158-3007    NIPPONDENSO INDUSTRIAL

•    No more crooked solenoid terminals
A158-3001
Hsg Sample


A158-3001

NIPPONDENSO INTERNAL BACK PLATE & STATOR PULLER
(updated design saves time and makes the job easier & faster)



  • updated with two bolt patterns on the puller to cover the old & new style Nippondenso alternators
  • bolt patters are countersunk allowing pulling of back plate and stator together....Time Saver
  • when repair the slip ring it is not necessary to separate the back plate from the stator.
  • you save time and money when the back plate is not separated because you save the diodes
  • Puller is stamped with an O for old style & two N's for new style
  • Placement:  The O is placed just below the battery terminal on the right side viewing from bottom of alternator and the first N is placed right just under the battery terminal and the second N is placed on top left stud.
A158-2000
A158-2000
GEAR REDUCTION STARTER DRIVE SPRAGUE LOADER

Applications:  Honda & Toyota
Previous Page Next Page
Tools Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 270