Previous Page
Next Page
Tools Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 291
V108-0100
V108-0100 Tool

V108-0100
Complete Serpentine Pulley Pulling Tool

•    Puller gripping range:  2 1/4” to 4”
•    Grips four grooves allowing complete coverage of all three of grooves
•    Can be used with 2 jaw puller, but works best with a gear and bearing puller using
    3.3” x 15 bolts with a pulling width from 3” to 6”. 
•    Can be purchased piece by piece.

Replacement Parts:
V108-0100-1  Puller Only       
V108-0100-2  T-Bar and Bolt   
V108-0100-3  Bolts, attaching 
V108-0100-3A Long Bolts
V108-0104-4  Flat Washers   
W558-1900-3
W558-1900-4&3
CLUTCH PULLEY/OAP OVERRUNNING
ALTERNATOR PULLEY REMOVING TOOLS


W558-1900-3
CLUTCH PULLEY REMOVING & INSTALLING TOOL
0.746" or 18.96mm Splines

•    For the lates design pulleys on domestic and import alternators
•    Clutch or Ratchet pulleys only
•    Not designed for pulley nut or lock washer types
•    These pulley’s can be CW or CCW, Check the arrow on the drive end housing for the proper rotation of the rotor fan..  Watch out or you can turn it the wrong way and ruin it.
•    Use with 17MM impact socket
•    When used in conjuction with W558-1900-4, an 11MM & a 17MM wrench are required


Applications:
Late Ford, Bosch Brazil, VW Golf, New Beattle, Bosch Germany & Mercedes, Hitachi, Delphi and more

MADE IN THE USA
W558-1900-4
W558-1900-4
ROTOR HOLDING TOOL

•    Allows pulley changing without alternator disassembly
•    11MM Hex Head with 12 Splines
•    Fits inside W558-1900-3 Clutch Pulley Removing Tool
C708-17MM-CP
C708-17MM-CPPully



C708-17MM-CP

CLUTCH PULLEY REMOVING & INSTALLING TOOL


•    For use with a 3/8” impact gun
•    Internal/Female hex
•    The pulley is screwed on the rotor shaft
•    No pulley nut is used
•    Pulleys may be CW or CCW, check arrow on the fron of the drive end housing

Application:  Ford, Bosch, Hitachi,  Delphi, Nippondenso, Valeo etc.


MADE IN THE USA
W558-1901
Pulley Only



W558-1901
Clutch & Decoupling Pulley Removing Tool


Vensel Enterprises introduces the latest Clutch and Decoupling Pulley Tool.  The W558-1901 Clutch Pulley Tool is designed for the latest model clutch pulley’s with internal splines having an OD of 0.540” or 13.70mm.


MADE IN THE USA

 

To Make Your Cutting More Efficient,
We Recommend Using F109-2591-262 Pro Tap for Steel & Copper and F109-2591-261 Alumimum Tap for Aluminum Cuts
F108-2328-061
F108-1615

MORE TOOLS FOR THE CLUTCH PULLEY APPLICATION


F108-2328-061                                     
PULLEY THREAD TAP                      

F108-1615
ROTOR SHAFT THREAD DIE
Previous Page Next Page
Tools Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 291